Phoenix Contact Flush-type Connector 4POS 0.5mm 5m A SCO

Caution: Avoid plugging in or disconnecting connectors under load. Improper use may cause damage. Ensure products are functioning properly and replace any damaged ones immediately. Only qualified electrical personnel should install and operate the product, following safety guidelines. Suitable for plant, controller, and electrical device engineering. Protect connectors from environmental influences in outdoor applications. Do not manipulate or improperly open assembled products. Use specified mating connectors. User responsible for direct connection with third-party manufacturers. Ground conductive connector housings for operating voltages > 50 V AC. Limit tensile load on connectors during cable laying. Observe technical data found on product, packing label, documentation, or online. Use recommended tools and protective caps for unused connectors. Ensure proper ground connection. Follow VDE 0100/1.97 411.1.3.2 and DIN EN 60 204/11.98 14.1.3 for combining circuits. Post warnings for connector surface heat-up. Features 4 positions, 'A' coding, II overvoltage category, 2.5 kV AC rated surge voltage, 250 V nominal voltage, 4 A nominal current, cable connection, 5 cable length, 0.5 mm cable cross-section, IP67 (when plugged in) degree of protection, -25C to 85C operating temperature range, according to IEC 61076-2-101 standards. Packed 1 pc, minimum order 10 pc, GTIN 4055626227313, weight 293.2 g (including packing), 21.69 g (excluding packing), made in DE. No REACH candidate substance above 0.1 wt%.